Micro ducts

Micro ducts are used for the mechanical protection of fibre optic micro cables - for direct burial or for the laying in pipe systems.

Straight connector with permanent locking to micro ducts to avoid accidental tear-out. Increased pressure limit. Disassembly of connector only possible with wrench.

Straight connector suitable for joining micro ducts of different sizes.
Locking clips to prevent tear-out of micro ducts to be purchased separately.

End cap with special seal to prevent penetration of water to installed micro ducts.
Locking clips to prevent tear-out of micro ducts to be purchased separately.

Connector with special seal to prevent penetration of gas to installed micro ducts.
Locking clips to prevent tear-out of micro ducts to be purchased separately.

Half-shell sealing element to prevent penetration of water and gas to micro ducts and cables inside.

Y enclosure for branching micro duct routes from 1 direction.
This solution is not water-proof.

T enclosure for branching micro duct routes from 2 directions.
This solution is not water-proof.

Inline enclosure for inter-connection of micro tubes in duct route.
This solution is water-proof (IP65).

H enclusure for branching micro duct routes.
This solution is water-proof.

Box for storing spare loop of micro cable.
Max. 50 m of micro cable up to 8 mm in size can be stored.

For direct-burial cables and micro ducts.
Rugged IP68 design.
Spring lock construction.
Waterproof and pressure-tight up to 10 bar.
Applicable also as repair closure that can be installed subsequently.