Micro ducts

Micro ducts are used for the mechanical protection of fibre optic micro cables - for direct burial or for the laying in pipe systems.

Straight connector with permanent locking to micro ducts to avoid accidental tear-out. Increased pressure limit. Disassembly of connector only possible with wrench.

Straight connector suitable for joining micro ducts of different sizes.
Locking clips to prevent tear-out of micro ducts to be purchased separately.

Transparent end cap to cover open micro ducts
and to prevent penetration of dirt.

End cap with special seal to prevent penetration of water to installed micro ducts.
Locking clips to prevent tear-out of micro ducts to be purchased separately.

Connector with special seal to prevent penetration of gas to installed micro ducts.
Locking clips to prevent tear-out of micro ducts to be purchased separately.

Half-shell sealing element to prevent penetration of water and gas to micro ducts and cables inside.

Locking clips to prevent accidental tear-out of micro ducts.

Plastic cap for temporary sealing of micro duct ends.

Shears for cutting micro ducts with outer diameter 4-28 mm.

Special knife with flat tip for stripping sheath of flat micro ducts.

Special tool for deburring inner edge of micro duct.

Y enclosure for branching micro duct routes from 1 direction.
This solution is not water-proof.

T enclosure for branching micro duct routes from 2 directions.
This solution is not water-proof.

Inline enclosure for inter-connection of micro tubes in duct route.
This solution is water-proof (IP65).

H enclusure for branching micro duct routes.
This solution is water-proof.

Box for storing spare loop of micro cable.
Max. 50 m of micro cable up to 8 mm in size can be stored.

For direct-burial cables and micro ducts.
Rugged IP68 design.
Spring lock construction.
Waterproof and pressure-tight up to 10 bar.
Applicable also as repair closure that can be installed subsequently.